address_family can
architecture linux

method static
  description
    This method may be used to setup an Controller Area Network (CAN)
    interface. It requires the the *ip* command from the *iproute* package.

  options
    bitrate bitrate		-- bitrate (1..1000000) *required*
    samplepoint samplepoint	-- sample point (0.000..0.999)
    loopback loopback		-- loop back CAN Messages (on|off)
    listenonly listenonly	-- listen only mode (on|off)
    triple triple		-- activate triple sampling (on|off)
    oneshot oneshot		-- one shot mode (on|off)
    berr berr			-- activate berr reporting (on|off) 

  up
    ip link set %iface% type can bitrate %bitrate%
    [[ ip link set %iface% type can loopback %loopback% ]]
    [[ ip link set %iface% type can listen-only %listenonly% ]]
    [[ ip link set %iface% type can triple-sampling %triple% ]]
    [[ ip link set %iface% type can one-shot %oneshot% ]]
    [[ ip link set %iface% type can berr-reporting %berr% ]]
    ip link set %iface% up

  down
    ip link set %iface% down